Protect Super and Protect Solution

Loose laid
The DDA (Disability Discrimination Act) states that loose lay should not be considered.

Adhered - Protect Super and Protect Solution
In frequently used areas the Zeno-Protect range of products should be adhered. For suitable adhesives check with the manufacturers (see links). The subfloor must be dry, smooth and stable. Adhesion must be carried out in accordance with instructions of the adhesive manufacturer.

Note: Zeno-Protect B.V. cannot be held responsible for the performance of the recommended adhesive. This information is intended as a guide only.

Download fitting instructions

Fitting Protect Star

Protect Star is easily cut with a sharp knife. It can be laid in a matwel or on any hard / smooth surface.

Matwell - instructions
Unroll Protect Star and allow to climatize for approx 8 hours at room temperature. Cut approx 2% oversize and use a blunt instrument to push Protect Star into the matwel. Protect Star can be but jointed. For joining two lenghts use a flat pvc tape and adhere with a coldweld paste.

* Roll measurements are approximate